2.3 N2 ELECTRONIC UNIT INJECTOR 12. Install the EUI terminal wires by positioning the keyhole in the terminal over the screw in the injector solenoid housing. Pull the terminal end down so that the screw rests in the smaller slot in the terminal. Torque the terminal screws to 1.08–1.13 N·m (9.5–10.0 lb·in.). Do not bend the terminals down after installation. See Figure 2-12. Figure 2-12 N2 Electronic Unit Injector Terminal Installation (Rev. 2005) All information subject to change without notice. 2-26 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION