Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 13. Install the rocker arm shafts, with rocker arms in place. Refer to section 1.3.3. NOTE: Front and rear rocker shaft assemblies look identical but are not interchangeable due to different bolt-hole center distances. The outboard end of each rocker shaft assembly is marked with the DDC logo for identification. Care should be taken to identify and return assemblies to the proper location if both overhead assemblies were removed. 14. Adjust the intake and exhaust valve clearances and injector height. Refer to section 13.2 15. Install the inlet and outlet fuel lines to the fittings at the rear of the cylinder head. See Figure 2-6. 16.

On DDEC III/IV engines, record the injector calibration code from the load plate with the proper cylinder location. 17. Install the valve rocker cover. Refer to section 1.6.7. 18. For one-piece valve rocker cover, refer to section 1.6.8. For two-piece and three-piece valve rocker cover, refer to section 1.6.9. 19. Verify repair of electronic unit injector. Refer to section 12.7. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-27