SERIES 60 SERVICE MANUAL 2.4.6 Installation of N2 Injector Tube and O-ring Perform the following steps for injector tube installation: NOTICE: DO NOT lubricate the outside of the injector tube or inside the cylinder head injector tube bore to facilitate installation of the tube. Lubricant may cause the tube to turn during reaming or flaring operations possibly damaging the injector tube or reamers. NOTE: This ring was formerly made of fluoroelastomer and had a blue coating for identification. It is now made of a special blended fluorocarbon material with a green teflon coating for identification.
Former and current-design seal rings are completely interchangeable, and only the current green-coated seal ring will be serviced. 1. Place the O-ring over the injector tube, sliding it up to the lip. See Figure 2-18. 2. Install the injector tube on J–33880–4 (part of tool set J–33880). See Figure 2-18. Figure 2-18 Installing O-ring and Injector Tube 3. Install both J–33880–4 (part of tool set J–33880) and injector tube into the injector bore. Ensure the tip of the injector tube goes through the small hole in the fire deck. Tap lightly on the end of the tool, if necessary, to seat the tube. All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-33