Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.4 N2 FUEL INJECTOR TUBE AND O-RING NOTICE: Turn the reamer in a clockwise direction only (both when inserting and withdrawing the reamer) because movement in the opposite direction will dull the cutting edges of the flutes. 12. Place a few drops of cutting oil on the cutting edges of J–33880–5 (part of tool set J–33880), and install it in J–33880–10 (part of tool set J–33880). See Figure 2-22. Figure 2-22 Reaming Injector Tube 13. Using a speed handle with 7/16 in. socket attached, turn the tip reamer in a clockwise direction using light pressure until it goes completely through the end of the injector tube.

EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 14. Remove J–33880–5 (part of tool set J–33880) and J–33880–10 (part of tool set J–33880). Blow out the injector tube and tip with compressed air to remove all metal shavings. (Rev. 2005) All information subject to change without notice. 2-36 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION