Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 8. Continue to rotate J–5286–6 (part of tool set J–33880) and apply pressure to the flare end of the tube firmly against the cylinder head casting tube opening. Do not exceed 41 N·m (30 lb·ft) torque. See Figure 2-21. Figure 2-21 Properly Flared Injector Tube Tip 9. Remove J–5286–6 and J–33880.The tapered lower end of the injector tube must provide a smooth and true seat for the lower end of the injector nut to effectively seal the cylinder pressures and properly position the injector tip into the combustion chamber. To ream the injector tube, complete the following steps: 10.

Install J–33880–3 (part of tool set J–33880), into the injector bore until it contacts the cylinder head. See Figure 2-22. 11. Install J–33880–10 (part of tool set J–33880), into the seat reamer pilot until it bottoms. See Figure 2-22. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-35