2.4 N2 FUEL INJECTOR TUBE AND O-RING NOTICE: If the seat reamer is dropped into the pilot, or is allowed to strike the injector, chatter marks may result in the injector tube seat. Use extreme care when inserting the seat reamer to prevent damaging the tube. 17. Place a few drops of cutting oil on the edges of J–33880–1 (part of tool set J–33880), and gently place it in the pilot. See Figure 2-24. Figure 2-24 Reaming Injector Tube Seat NOTICE: Turn the reamer in a clockwise direction only, because movement in the opposite direction will dull the cutting edges of the flutes. 18. Using a speed handle with 15/16 in.
socket attached, turn the seat reamer in a clockwise direction with light pressure. Continue until J–33880–1 (part of tool set J–33880) bottoms against J–33880–20 (part of tool set J–33880). (Rev. 2005) All information subject to change without notice. 2-38 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION