SERIES 60 SERVICE MANUAL 19. Inspect the tube seating surface to ensure that there are no irregularities or chatter marks in the seating surface. If irregularities or chatter marks are found, remove and replace the injector tube. See Figure 2-25. Figure 2-25 Injector Tube Seat Irregularities EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 20. Remove the reamer and pilot. Clean out the injector tube with compressed air. 21. Remove the two head bolts and J–33880–20 (part of tool set J–33880) from the cylinder head.
All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-39