2.4 N2 FUEL INJECTOR TUBE AND O-RING 22. Spot-face the injector tube as follows: [a] With the cylinder head firedeck in a workable position, insert the J–5286–8 (part of tool set J–33880), into the injector tube. See Figure 2-26. Figure 2-26 Refinishing Injector Tube Recess [b] Using a 12-point socket and speed handle, turn the refinisher to remove excess stock so that the lower end of the injector tube is from flush to -0.20 mm (-0.008 in.) below the firedeck surface of the cylinder head. To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure.
EYE INJURY [c] Remove the chips from the injector tube with compressed air. See Figure 2-26. (Rev. 2005) All information subject to change without notice. 2-40 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION