Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.5 N3 ELECTRONIC UNIT INJECTOR 2.5 N3 ELECTRONIC UNIT INJECTOR Engine models built after December 1, 2003 will use the N3 Electronic Unit Injector (EUI). See Figure 2-28. 1. Injector Follower 4. Injector Nut 2. Plunger 5. Injector Spring Cage 3. Module 6. Nozzle Figure 2-28 N3 Electronic Unit Injector Cross-Section The N3 injector is designed as an inline concept. The fuel metering unit or module is positioned under the plunger, so the overall envelope of the N3 is smaller than previous injectors. The N3 has an inwardly opening of solenoid valve which controls beginning of injection and end of injection.

The solenoid valve closing point defines the beginning of injection (BOI) and the solenoid valve opening point defines the end of injection (EOI). Pressure is generated by the downward movement of the plunger in combination with the closed solenoid valve. Fuel quantity is metered by the length of time the solenoid valve remains closed. A magnetic core is incorporated into the module. The electrical leads from the core are brought to an external position on the injector through a modular two-pin connector socket. The advantages of the N3 injector are: Improved strength. Reduced external leakage potential. Compact design. Reduced weight. (Rev.

2005) All information subject to change without notice. 2-42 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION