Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL The amount of fuel injected and the beginning of injection timing is determined by the Electronic Control Unit (ECU). The ECU sends a command pulse which activates the injector solenoid. The N3 EUI performs four functions: Creates the high-fuel pressure required for efficient injection. Meters and injects the exact amount of fuel to handle the load. Atomizes the fuel for mixing with the air in the combustion chamber. Permits continuous fuel flow for component cooling. Engine combustion is obtained by injecting, under pressure, a small quantity of accurately metered and finely atomized fuel oil into the cylinder.

Metering and timing of the fuel is accomplished by the ECU which actuates the solenoid control valve to stop the free flow of fuel through the injector. When the solenoid control valve closes, fuel is trapped in the injector body and under the plunger. The continuous fuel flow through the injector prevents air pockets in the fuel system and cools those injector parts subjected to high combustion temperatures. Fuel enters the injector through the fuel inlet opening located around the injector body. See Figure 2-29. Figure 2-29 N3 Fuel Injector Body All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-43