Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL After entering the nut cavity, the fuel passes through a drilled passage into the module and plunger area. See Figure 2-28. The plunger operates up and down in the body bore of the injector. The motion of the injector rocker arm is transmitted to the plunger and follower that bears against the follower spring. As the piston moves approximately two-thirds of the way up in the cylinder on the compression stroke, the injector cam lobe begins to lift causing the injector rocker arm to push down on the follower and the plunger. Just before injection begins, the ECU sends an electronic pulse which turns on the injector solenoid.

The energized solenoid creates a magnetic force which closes the control valve and traps fuel under the plunger and passages leading down to the needle valve. The fuel pressure increases as the plunger continues its downward stroke. This fuel pressure acts on the needle valve. When it creates a force high enough to overcome the valve spring force holding the needle on its seat, the needle valve moves up, allowing the high pressure fuel to spray into the combustion chamber. The high pressure of the fuel passing through the small holes in the nozzle creates a finely atomized spray for combustion within the cylinder.

After the pulse width time has passed, the ECU turns off the current to the injector solenoid. The de-energized solenoid allows a spring to open the control valve, permitting the trapped fuel to spill down, dropping the pressure within the injector. When the pressure is low enough the needle valve closes and ends injection The beginning of injection and metering of the fuel in relation to the crankshaft position are controlled by the ECU. Injection begins soon after the control valve is closed. The valve closing point known as the injector response time is returned to the ECU.

This information is used to monitor and adjust injection timing, thus removing injector-to-injector variation influences on timing. The amount of fuel injected depends on the pulse width stored in the calibration which determines how long the control valve remains closed; the larger the pulse width the longer the valve is closed and the more fuel is injected. When the injector rocker arm has completed its downward travel the injector follower spring returns it to the starting position. As the plunger moves up fuel enters the injector pumping cavity for another injection cycle.

The constant circulation of fuel through the injector renews the fuel supply in the chamber and aids the cooling of the injector. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-45