2.5 N3 ELECTRONIC UNIT INJECTOR Figure 2-32 Cylinder Head Fuel Fitting Locations 3. Remove the two rocker shaft through-bolts and one nut for each rocker shaft assembly, and lift the rocker shaft assembly off the engine. Refer to section 1.3.2 Remove the N3 injector as follows: NOTE: Do not pry on injector connector at anytime. 1. Disconnect the vehicle battery power before servicing the N3 EUI to prevent failure of the DDEC V ECU. 2. Disengage the locking tang on the harness plug connector. Grasp the connector and gently pull it from the socket. 3. Remove injector hold down bolt and washer. (Rev. 2005) All information subject to change without notice.
2-48 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION