Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL [c] Inspect fuel injectors for damage and replace as required. 2. If the coolant system is contaminated with fuel, flush and reverse flush the system . Refer to section 14.6.4 EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. NOTICE: Leftover fuel must be removed from the injector bore before injector installation. If fuel is trapped between the top of the injector hole tube and the lower injector O-ring seal, it may seep down to the injector hole tube seal ring, causing swelling and possible seal leakage. 3.

Using clean compressed air, blow out any fuel remaining in the injector bore. NOTICE: Injector O-ring seals and injector washers are considered one-use items and cannot be reused. Any time an injector is removed, all three injector O-ring seals and injector washers must be replaced with new parts. Failure to replace O-ring seals and injector washer can result in leakage. 4. Check to make sure the injector bore is thoroughly clean. NOTE: The injector tube bore should be cleaned and inspected for damage before installation of the N3 Electronic Unit Injector. Refer to section 2.6.1.1. 5. Install a new washer on injector, ensure the smooth side of the washer faces down into the cylinder head.

The stepped side of the washer must face up to the injector. NOTE: All external O-rings must be lubricated prior to installation into the cylinder head. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-51