2.5 N3 ELECTRONIC UNIT INJECTOR NOTICE: Avoid wire brushing the spray holes to prevent damage. 5. Cover the injector hole in the cylinder head to keep out foreign material. Remove carbon from the injector exterior in the area where the tip joins the nut, using wire buffing wheel (J–7944). 2.5.3 Disassembly of N3 Electronic Unit Injector On a Series 60 engine that uses the N3 EUI, only the injector seal rings and injector washer are serviceable. The injector must not be disassembled. 2.5.3.1 Inspection of the N3 Electronic Unit Injector Inspect the N3 Electronic Unit Injector as follows: 1. Inspect the N3 injector body for visible damage replace if damaged. 2.
Inspect the O-rings and injector washer for cracks or damage replace if necessary. See Figure 2-35. Figure 2-35 N3 Injector Seal Rings 2.5.4 Installation of the N3 Electronic Unit Injector Perform the following steps: 1. If the fuel system is contaminated with coolant: [a] Drain the fuel tanks and refill with clean fuel. Refer to section 14.6.2. [b] Replace both filters with new, and clean the fuel/water separator, if equipped. Refer to section 2.10.2. (Rev. 2005) All information subject to change without notice. 2-50 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION