2.5 N3 ELECTRONIC UNIT INJECTOR 8. Install the N3 EUI harness plug into the injector connector making sure the locking tang clicks into place. See Figure 2-38. Figure 2-38 N3 Injector and Harness Connection 9. Install the rocker arm shafts, with rocker arms in place. Refer to section 1.3.3. 10. Adjust the intake and exhaust valve clearances and injector height. Refer to section13.2. 11. Install the inlet and outlet fuel lines to the fittings at the rear of the cylinder head. See Figure 2-6. 12. On DDEC V engines, record the injector calibration code from the name plate with the proper cylinder location see Figure 2-38. 13. Install the valve rocker cover. Refer to section 1.6.7. 14.
For one-piece valve rocker cover, refer to section 1.6.8. For two-piece and three piece valve rocker cover, refer to section 1.6.9. 15. Reconnect the vehicle battery power. 16. Verify installation of N3 Electronic Unit Injector. Refer to section 12.7. (Rev. 2005) All information subject to change without notice. 2-54 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION