Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 2.6 N3 FUEL INJECTOR TUBE The bore in the cylinder head for the N3 EUI is directly through the cylinder head water jacket. To prevent coolant from contaminating the injector and still maintain maximum cooling of the injector, a stainless steel tube is screwed into the injector bore. The tube has a O-ring installed to create a water and gas-tight seal. NOTE: It is recommended that the injector tube be replaced with new a O-ring at the time of engine over haul. The injector tube is reusable. NOTE: Do not remove the injector tube for inspection unless a fault in the tube is suspected.

2.6.1 Removal of the N3 Injector Tube Perform the following steps to remove the injector tube: 1. Remove Rocker Shaft assemblies. Refer to section 1.3.2. 2. Remove N3 injector. Refer to section 2.5.2. NOTICE: Engine coolant must be drained prior to injector tube removal. 3. Drain engine coolant.Refer to section14.6.4. NOTICE: Do not use excessive force on the injector tube during removal, cracking of the injector tube may occur requiring replacement. 4. Install cup tool (J–46904) into injector bore and align tool with slots in tube and turn counter clockwise to remove. 2.6.1.1 Inspection of N3 Injector Tube Inspect the injector tube as follows: 1. Inspect injector tube for cracks or defects.

If defective replace injector tube. 2. Clean injector tube threads with a fine wire brush, being careful not to abrade the cylinder head to injector tube sealing surface. 3. Clean the injector tube interior sealing surface, a chemical solvent maybe used for cleaning interior sealing surface. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-55