2.6 N3 FUEL INJECTOR TUBE 2.6.2 Installation of N3 Injector Tube and Seal Perform the following steps for injector tube installation: 1. Clean injector bore of debris. NOTE: Replace with new O-ring when injector tube is removed or replaced. 2. Install O-ring in groove on injector tube, a small amount of silicone based O-ring lubrication will aid in the installation. See Figure 2-39. Figure 2-39 N3 Injector Tube and O-ring 3. Coat the threads of injector tube with a high temperature nickel based antiseize lubricant. 4. Install the injector tube on cup (J–46904). See Figure 2-40. Figure 2-40 Installation of N3 Injector Tube on Cup Tool (J–46904) (Rev.
2005) All information subject to change without notice. 2-56 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION