SERIES 60 SERVICE MANUAL 5. Using cup tool (J–46904) install injector tube in injector bore. See Figure 2-41. Figure 2-41 Installation of N3 Injector Tube in Cylinder Head 6. Torque injector tube to 35-45 N·m (26-33 lb·ft). 7. Release torque approximately 180 degrees. 8. Torque injector tube to 35-45 N·m (26-33 lb·ft) ensure the tip of the injector tube is flush or below the fire deck, the tube should not protrude. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-57