Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 2.7.2 Removal of Former Fuel Pump Perform the following steps for fuel pump removal: 1. Disconnect the fuel lines from the inlet and outlet openings of the fuel pump. 2. Remove the three fuel pump attaching bolts and withdraw the pump from the mounting adaptor on the gear case or air compressor. 3. Check the drive coupling and, if broken or worn, replace it with a new coupling. 2.7.3 Disassembly of Former Fuel Pump Perform the following steps for fuel pump disassembly: 1. With the fuel pump removed from the engine, clamp the pump in a bench vise equipped with soft jaws. 2. Remove fuel inlet and outlet fittings from fuel pump cover. 3. Remove access hole plug. 4.

Use snap ring pliers (J–4880) and remove outer drive hub positioning C-clip. NOTE: It may be necessary to rotate the drive hub and shaft to align the set screw with access hole. 5. Working through access hole, loosen but do not remove set screw securing drive hub to drive key. 6. Slide drive hub off shaft and remove drive key from shaft. 7. Use snap ring pliers (J–4880) and remove inner drive hub positioning C-clip. 8. Position pump on holding fixture (J–38767–1) hub side down. See Figure 2-48. Figure 2-48 Fuel Pump Holding Fixture All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-65