Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.7 FUEL PUMP WITH SEPARATE DRIVE SHAFT AND HUB 9. Using a No. E-8 torx socket (J–25359–11, part of tool set J–25359–C), remove eight (8) bolts securing the pump cover to body. NOTE: Note the color of the foil gasket, gold or silver. If the pump is reassembled, the same color foil gasket must be used. The gaskets are of different thickness and establish correct internal clearance. 10. Separate the pump cover from the body by lifting it off the shafts and dowels. Remove and discard the foil gasket between the cover and body. NOTE: When the drive shaft is removed from the pump, the oil seals must be replaced. 11. Withdraw the driven shaft, drive shaft, and gear assemblies from the pump body.

12. Remove the C-clips that retain the gears on the shafts, taking care not to misplace the drive pin from the drive shaft or the key from the drive shaft. 13. Remove the gears from the shafts. NOTE: When the drive shaft is removed, the drive shaft needle bearing assembly in the pump body must also be removed to allow installation of the oil seal protector used during reassembly. 14. Use needle bearing remover (J–33853) with slide hammer and remove the needle bearing assemblies from the pump body and cover. See Figure 2-49. Figure 2-49 Needle Bearing Removal (Rev. 2005) All information subject to change without notice. 2-66 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION