Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.7 FUEL PUMP WITH SEPARATE DRIVE SHAFT AND HUB 2.7.3.1 Cleaning and Inspection of Former Fuel Pump Perform the following steps to clean and inspect the fuel pump parts: EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 1. Clean all parts with clean fuel oil, before inspection. 2. Dry the parts with compressed air. 3. Visually inspect the drive coupling and hub for wear or damage. [a] If wear or damage is found, replace the drive coupling and hub. [b] If no wear or damage is found. Reuse the drive coupling and hub. 4.

Oil seals, once removed, must be discarded and replaced with new seals. Oil seals must be removed whenever the fuel pump drive shaft is withdrawn. 5. Visually inspect the drive and idler gear shafts for scoring or wear. [a] If scoring or wear is found, replace the drive and idler gear shafts. [b] If no scoring or wear is found, reuse the drive and idler gear shafts. 6. Visually check the gear teeth for scoring, chipping or wear. [a] If gear teeth are scored, chipped or worn, replace the parts as necessary. [b] If gear teeth are not scored, chipped or worn, reuse the parts. 7. Visually inspect the relief valve. The valve must be free of score marks and burrs.

[a] If the relief valve is scored and cannot be cleaned up with fine emery cloth, replace the relief valve. [b] If the relief valve is not damaged, reuse the part. (Rev. 2005) All information subject to change without notice. 2-68 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION