2.7 FUEL PUMP WITH SEPARATE DRIVE SHAFT AND HUB 18. Carefully insert the drive hub end of the drive shaft through the needle bearing assembly and into the seal protector. Ensure the shaft is fully seated in the seal protector. 19. Hold the shaft down in the seal protector and lift the pump body up against the gear. With the gear in contact with the pump body, lift the body and remove the seal protector from the drive shaft. NOTE: Hold the shaft in position with the gear against the pump body to ensure the drive hub C-clip grooves do not contact the oil seals. 20. Position the pump body on the holding fixture (J–38767–1, part of tool set J–38767–A) hub side down. NOTE:
When assembling pump, always use the same color foil gasket that was originally installed and is listed in Table 2-1. If the color is unknown, measure the depth of the gear cavity in the pump cover and install the required gasket. Table 2-1 Gasket Color vs. Gear Cavity Depth Chart (Former Fuel Pump) (Rev. 2005) All information subject to change without notice. 2-74 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION Gear Cavity Depth Color Gasket Used 6.320-6.325 mm (0.24885-0.24905 in.) Blue 6.326-6.331 mm (0.24906-0.24925 in.) Amber 6.333-6.338 mm (0.24935-0.24955 in.) Gold 6.339-6.344 mm (0.24956-0.24975 in.) Silver