Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 21. Place a new foil gasket on the face of the pump. With a finger tip, carefully smooth the gasket against the face to ensure there are no wrinkles, creases or bubbles. If present, and they cannot be removed with the finger, remove the gasket and repeat the procedure. 22. Carefully insert the driven shaft and gear assembly in the needle bearing in the pump body. NOTE: When positioning the cover, the fuel inlet (stamped on cover) must be on the side of the relief valve bore in the pump body. 23. Position the needle bearing assemblies in the pump cover on the ends of the driven and drive shafts and slide the cover against the pump body. 24.

Install eight (8) cover retaining bolts. Use No. E-8 torx socket (J–25359–11, part of tool set J–25359–C) and torque bolts to 12-15 N·m (9-11 lb·ft). NOTE: As the outside of the pump body and cover are not machined and to prevent possible distortion, ensure that only the pump cover is gripped and that the vise jaws do not contact both body and cover. 25. Clamp the fuel pump cover in a soft-jawed vise with the relief valve bore in the pump body positioned up. 26. Lubricate the relief plunger with clean engine oil and insert the plunger into the bore with the hollow end up. Insert the relief spring inside the plunger and the pin inside the spring. 27.

Install the spacer in the bottom of the spring seat in the plug and install a new O-ring seal under the head of the plug. Thread the plug into the pump body and torque to 8-14 N·m (6-10 lb·ft). 28. Place the pump assembly on a bench, hub side up. Coat the surface of the outer seal with a small amount of lithium base all purpose grease. 29. Use snap ring pliers (J–28507) and install inner drive hub positioning C-clip in its groove in the shaft. 30. Remove the set screw from the drive hub and apply one drop of Loctite® 242 (or equivalent) to the threads and reinstall the set screw two or three turns. 31.

Install the hub drive key in the groove on the shaft and slide the hub on the shaft indexing the keyway in the hub with the key in the shaft. 32. Use snap ring pliers and install outer hub retaining C-clip in groove. 33. Rotate the drive shaft and hub to align the hub set screw with the access hole in the pump body. Torque the set screw to 3.8 N·m (2.8 lb·ft). 34. Install access hole plug. 35. Install fuel inlet and outlet fittings in the pump cover. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-75