Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.7 FUEL PUMP WITH SEPARATE DRIVE SHAFT AND HUB 2.7.5 Installation of Former Gear Train-Driven Fuel Pump Install the fuel pump as follows: NOTICE: It may be necessary to use a brass hammer or fiber mallet to seat the drive assembly. Be careful not to damage the O-ring on installation. 1. Install the drive assembly on the gear case. 2. Install the fuel pump drive bolts and torque to 30-34 N·m (22-25 lb·ft) using the torque pattern. See Figure 2-56. Figure 2-56 Fuel Pump Drive Retaining Bolt Torque Sequence 3. Using a new gasket, install the fuel pump and torque bolts to 30-38 N·m (22-28 lb·ft). 4. Install any other components that were removed for this procedure. 5.

Connect fuel inlet and outlet lines to the fuel pump and tighten. 6. Prime the fuel system before starting the engine. (Rev. 2005) All information subject to change without notice. 2-76 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION