2.8 FUEL PUMP WITH ONE-PIECE DRIVE SHAFT AND HUB ASSEMBLY 1. Driven Shaft 6. Oil Seal 2. Cover 7. Pump Body 3. Drive Gear 8. Spline Drive Shaft 4. Gasket 9. Steel Cage Ball Bearing 5. Snap Ring Figure 2-58 Current Gear Case-Mounted Fuel Pump Assembly Former and improved pump assemblies are completely interchangeable. However, components of former and improved pump assemblies are not interchangeable. The current fuel pump system consists of the following components: Barnes positive displacement type fuel pump with one-piece drive shaft and hub assembly Gear train mounting adaptor NOTE:
Effective with engine serial number 06R0549855 built on October 19, 1999, gear case-mounted fuel pumps have a splined drive shaft and splined gear coupling assembly. See Figure 2-58. The former and current fuel pump and fuel pump drive assemblies are not interchangeable. Both current assemblies must be used together. Components of former and current pump assemblies and drive assemblies are not interchangeable. (Rev. 2005) All information subject to change without notice. 2-80 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION