SERIES 60 SERVICE MANUAL See Figure 2-59for the current positive displacement gear-type fuel pump is shown in the next illustration. 1. Gear Case-Mounted Fuel Pump Assembly 5. Air Compressor-Mounted Fuel Pump 2. Gear Case Housing 6. Air Compressor Assembly 3. Fuel Pump Drive Adaptor 7. Brass Fittings 4. Brass Fittings Figure 2-59 Gear Case and Air Compressor-Mounted Fuel Pumps The fuel pump transfers fuel from the supply tank to the fuel injectors. The pump circulates an excess supply of fuel through the injectors, which purges the air from the system and cools the injectors. The unused portion of fuel returns to the fuel tank by means of a fuel return line.
The fuel pump is either attached to a drive assembly mounted on the rear side of the gear case, or driven off of the rear of the air compressor. See Figure 2-59. The fuel pump cover and body are positioned by two dowels. The dowels aid in maintaining alignment between the body, cover and shafts. The mating surfaces of the pump body and cover are perfectly flat ground surfaces. A gasket is used between the cover and body. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-81