2.8 FUEL PUMP WITH ONE-PIECE DRIVE SHAFT AND HUB ASSEMBLY The fuel pump body is recessed to provide running space for the pump gears. Recesses are also provided at the inlet and outlet positions of the gears. The small relief valve vent (5) (see Figure 2-60) permits the fuel oil in the inlet side of the pump to lubricate the relief valve at its outer end. This eliminates the possibility of a hydrostatic lock which would render the relief valve inoperative. Pressurized fuel contacts the relief valve through the passage to the head of the relief valve (1) and provides for relief of excess discharge pressures.
Fuel re-enters the inlet side of the pump through the passage to the head of the relief valve (6) when the discharge pressure is great enough to move the relief valve back from its seat. Part of the relief valve may be seen through the passage to the head of the relief valve (6). The gear teeth vent cavity (7) provides escape for the fuel oil that is squeezed out of the gear teeth as they mesh together on the discharge side of the pump. Otherwise, fuel trapped at the root of the teeth would tend to force the gears apart, resulting in undue wear on the gears, shafts, body, and cover. See Figure 2-60. 1. Passage to Head of Relief Valve, Pressure Side 10. Dowel 2. Dowel Hole 11. Drive Gear 3.
Body 12. Drive Shaft Gear 4. Oil Seal Vent to Suction Side 13. Relief Valve 5. Relief Valve Vent to Suction Side 14. Spring 6. Passage to Head of Relief Valve, Suction Side 15. Pin 7. Gear Teeth Vent Cavity 16. O-ring 8. Cover 17. Plug 9. Driven Gear 18. Spacer Figure 2-60 Fuel Pump (Rev. 2005) All information subject to change without notice. 2-82 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION