Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.8 FUEL PUMP WITH ONE-PIECE DRIVE SHAFT AND HUB ASSEMBLY 2.8.2 Removal of Fuel Pump (One-piece Drive Shaft) Perform the following steps for fuel pump removal: 1. Disconnect the fuel lines from the inlet and outlet openings of the fuel pump. 2. Remove the three fuel pump attaching bolts and withdraw the pump from the mounting adaptor on the gear case or air compressor. 3. Check the drive coupling and, if broken or worn, replace it with a new coupling. 2.8.3 Disassembly of Fuel Pump (One-piece Drive Shaft) Perform the following steps for fuel pump disassembly: 1. With the fuel pump removed from the engine, clamp the pump in a bench vise equipped with soft jaws. 2.

Remove fuel inlet and outlet fittings from fuel pump cover. 3. Remove the pump from the vise and position pump on holding fixture (J–38767–1) hub side down. See Figure 2-63. Clamp the holding fixture in the vise. Figure 2-63 Fuel Pump Holding Fixture (Rev. 2005) All information subject to change without notice. 2-86 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION