Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 4. Using a No. E-8 torx socket (J–25359–11, part of tool set J–25359–C)), remove eight (8) bolts securing the pump cover to body. NOTE: Note the color of the foil gasket, gold or silver. If the pump is reassembled, the same color foil gasket must be used. The gaskets are of different thickness and establish correct internal clearance. 5. Separate the pump cover from the body by lifting it off the shafts and dowels. Remove and discard the foil gasket between the cover and body. NOTE: When the drive shaft is removed from the pump, the oil seals must be replaced. 6. Withdraw the driven shaft and gear and the drive shaft and gear assemblies from the pump body. 7.

Remove the C-clips, and key from the drive shaft. Remove the C-clips and pin from the driven shaft. 8. Remove the gears from the shafts. NOTE: When the drive shaft is removed, the drive shaft needle bearing assembly in the pump body must also be removed to allow installation of the oil seal protector used during reassembly. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-87