Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.8 FUEL PUMP WITH ONE-PIECE DRIVE SHAFT AND HUB ASSEMBLY 9. Use needle bearing remover (J–33853) with slide hammer and remove the needle bearing assemblies from the pump body and cover. See Figure 2-64. Figure 2-64 Needle Bearing Assembly Removal 10. Position pump on fixture (J–38767–1) and insert the lip of seal remover (J–1508–13) between the inner and outer oil seals. Tap the tool with a light hammer to drive the outer seal out of the pump body. See Figure 2-65. Discard the outer seal. Figure 2-65 Oil Seal Removal 11. Repeat the process, removing the inner seal by placing the tool lip against the inside of the seal case. Discard the inner seal. (Rev.

2005) All information subject to change without notice. 2-88 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION