Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 2.8.4 Assembly of Fuel Pump (One-piece Drive Shaft) Perform the following steps for fuel pump assembly: 1. Lubricate the lips of a new inner oil seal and pilot of oil seal installer (J–1508–8) with a light film of clean engine oil. 2. Place the oil seal adaptor (J–34158) on the pilot (J–1508–8) with the wide end of the adaptor against the handle. 3. Place inner oil seal on the pilot (J–1508–8) with seal case against the adaptor. 4. Support the pump body on wood blocks, hub side up, and insert the pilot into the shaft bore positioning the seal on the bore. Use a light hammer and drive the inner seal into the bore until the adaptor is bottomed against the pump body.

See Figure 2-66. Figure 2-66 Installing Inner Oil Seal All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-91