Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.8 FUEL PUMP WITH ONE-PIECE DRIVE SHAFT AND HUB ASSEMBLY 5. Remove the installer (J–1508–8) and pilot (J–34158) and place the narrow end against the installer handle. See Figure 2-67. Figure 2-67 Installing Outer Oil Seal 6. Place a new outer seal on J–1508–8 with J–34158 faced away from the adaptor. 7. Carefully reinsert the installer pilot (J–1508–8) through the inner seal and position the outer seal on the bore. Use a light hammer and drive the seal into the bore until the adaptor is bottomed against the pump body. 8. Install seal protector (J–33021–A) on drive shaft and hub assembly and install through seal. Remove seal protector. See Figure 2-68.

Figure 2-68 Seal Protector Installation NOTE: The bearing numbers should always be against the tool during installation. (Rev. 2005) All information subject to change without notice. 2-92 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION