Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 9. Install drive shaft needle bearings, using J–38767–8 (part of tool set J–38767–A). The new tool permits bearing installation over drive shaft. Tool J–33854 can and should be used to install the other three bearings as shown. See Figure 2-69 (this tool will support the bearing cages). Figure 2-69 Drive Shaft Bearing Installation 10. Install C-clip, key, gear, the final C-clip on drive shaft. NOTE: Hold the shaft in position with the gear against the pump body while handling to ensure the drive hub C-clip grooves do not contact the oil seals. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-93