2.8 FUEL PUMP WITH ONE-PIECE DRIVE SHAFT AND HUB ASSEMBLY 11. Position the pump body on the holding fixture (J–38767–1) hub side down. NOTE: When assembling pump, always use the same color foil gasket that was originally installed. Required gaskets for gear driven pump are listed in Table 2-3. Required gaskets for air compressor-driven pumps are listed in Table 2-4. If the color is unknown, measure the depth of the gear cavity in the pump cover and install the required gasket. Table 2-3 Gasket Color vs. Gear Cavity Depth Chart (Gear Driven Pumps) Table 2-4 Gasket Color vs. Gear Cavity Depth Chart (Air Compressor-Driven Pumps) (Rev. 2005) All information subject to change without notice.
2-94 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION Gear Cavity Depth Color Gasket Used 6.320-6.325 mm (0.24885 - 0.24905 in.) Blue 6.326-6.331 mm (0.24906 - 0.24925 in.) Amber 6.333-6.338 mm (0.24935 - 0.24955 in.) Gold 6.339-6.344 mm (0.24956 - 0.24975 in.) Silver Gear Cavity Depth Color Gasket Used 9.495-9.500 mm (0.37385-0.37405 in.) Blue 9.501-9.505 mm (0.37406-0.37425 in.) Amber 9.508-9.513 mm (0.37435-0.37455 in.) Gold 9.514-9.518 mm (0.37456-0.37475 in.) Silver