Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 12. Place a new foil gasket on the face of the pump. With a finger tip, carefully smooth the gasket against the face to ensure there are no wrinkles, creases, or bubbles. [a] If wrinkles, creases, or bubbles are present, and they cannot be removed with the finger, remove the gasket and repeat the procedure. 13. Assemble the driven gear shaft assembly by installing the C-clip on the shaft, and then installing the square-headed location pin in the hole in the shaft. Next, slide the driven gear on the shaft, aligning the pin on the shaft with the slot in the gear. Finally, install the C-clip on the shaft to hold the gear in place. 14.

Carefully insert the driven shaft and gear assembly in the needle bearing in the pump body. NOTE: When positioning the cover, the fuel inlet (stamped on cover) must be on the same side as the relief valve bore in the pump body. 15. Position the needle bearing assemblies in the pump cover on the ends of the driven and drive shafts and slide the cover against the pump body. 16. Install eight cover retaining bolts. Use No. E-8 torx socket (J–25359–11, part of tool set J–25359–C) and torque bolts to 12-15 N·m (9-11 lb·ft). NOTE:

As the outside of the pump body and cover are not machined and to prevent possible distortion, ensure that only the pump cover is gripped and that the vise jaws do not contact both body and cover. 17. Clamp the fuel pump cover in a soft-jawed vise with the relief valve bore in the pump body facing up. 18. Lubricate the relief plunger with clean engine oil and insert the plunger into the bore with the hollow end up. Insert the relief spring inside the plunger and the pin inside the spring. 19. Install the spacer in the bottom of the spring seat in the plug and install a new O-ring seal under the head of the plug. Thread the plug into the pump body and torque to 8-14 N·m (6-10 lb·ft). 20.

Place the pump assembly on a bench, hub side up. Install the coupling onto the hub. 21. Install fuel inlet and outlet fittings in the pump cover. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-95