Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.8 FUEL PUMP WITH ONE-PIECE DRIVE SHAFT AND HUB ASSEMBLY 2.8.5 Installation of Gear Train-Driven Fuel Pump (One-piece Drive Shaft) Install the fuel pump as follows: NOTICE: It may be necessary to use a brass hammer or fiber mallet to seat the drive assembly. Be careful not to damage the O-ring on installation. NOTE: Effective with engine serial number 06R0549855 built on October 19, 1999, gear case-mounted fuel pumps have a splined drive shaft and splined gear coupling assembly. See Figure 2-58. The former and current fuel pump and fuel pump drive assemblies are not interchangeable. Both current assemblies must be used together.

Components of former and current pump assemblies and drive assemblies are not interchangeable. 1. Using a new O-ring seal, install the drive assembly on the gear case. 2. Install the fuel pump drive bolts and torque to 30-34 N·m (22-25 lb·ft) using the torque pattern shown. See Figure 2-70. Figure 2-70 Fuel Pump Drive Retaining Bolt Torque Sequence (Rev. 2005) All information subject to change without notice. 2-96 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION