Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.9 FUEL PUMP DRIVE The fuel pump drive assembly consists of an aluminum housing, a helical gear driven off the bull gear, a drive shaft supported in the middle by a double-row ball bearing, and a forked hub that mates with a drive coupling. The fuel pump drive is supplied as an assembly, so components are not serviced. The drive gear and hub are pressed onto the drive shaft. A rubber O-ring located in a groove machined into the mounting surface of the drive is used to seal the fuel pump assembly to the gear case. An internal-type snap ring is fitted to a groove in the fuel pump drive housing to retain the bearing and shaft. see Figure 2-72 NOTE:

Effective with engine serial number 06R0549855 built on October 19, 1999, gear case mounted fuel pumps have a splined drive shaft and splined gear coupling assembly, see Figure 2-72. The former and current fuel pump drive assemblies are not interchangeable. Both current assemblies must be used together. Components of former and current pump assemblies and drive assemblies are not interchangeable. 1. Nut 6. Hub 2. Gear 7. Coupling 3. Bolt 8. Fuel Pump Drive Assembly 4. Splined Shaft 9. O-ring 5. Fuel Pump Figure 2-72 Current and Former Fuel Pumps The coupling between the fuel pump and fuel pump drive hubs is plastic, and acts as a shock absorber in the fuel pump drive line. (Rev.

2005) All information subject to change without notice. 2-100 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION