Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 2.9.1 Lubrication of Fuel Pump Drive Bearing The fuel pump drive bearing is lubricated by engine oil splash-fed by the gears rotating in the gear case. This oil feeds the bearing and drive shaft through a hole in the fuel pump drive housing. 2.9.2 Removing Fuel Pump Drive Assembly Remove the fuel pump drive assembly as follows: 1. Remove the bolts retaining the assembly to the gear case. NOTICE: Failure to remove the fuel pump drive assembly by pulling it straight may damage the O-ring. 2. Remove the fuel pump drive assembly by pulling it straight out of the gear case. 2.9.2.1 Clean the Fuel Pump Drive Assembly Clean the fuel pump drive assembly as follows: 1.

Clean the mating surfaces of the fuel pump drive assembly and gear case with fuel oil. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 2. Dry the fuel pump drive assembly with compressed air. 2.9.2.2 Inspection of Fuel Pump Drive Assembly Perform the following to inspect the fuel pump drive assembly: 1. The fuel pump drive assembly is nonserviceable if the bearing is worn or scored. Replace the fuel pump drive assembly. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-101