2.9 FUEL PUMP DRIVE 2.9.3 Installation of Fuel Pump Drive Assembly Perform the following steps to install the fuel pump drive assembly: 1. Replace the O-ring as necessary. 2. Lubricate the O-ring with a light coating of petroleum jelly. 3. Install the O-ring on the fuel pump housing. 4. Install the drive assembly on the gear case. NOTE: It may be necessary to use a brass hammer or fiber mallet to seat the drive assembly. Be careful not to damage the O-ring during installation. 5. Install the fuel drive bolts and torque to 30-34 N·m (22-25 lb·ft) using the torque pattern shown. See Figure 2-73. Figure 2-73 Fuel Pump Drive Assembly Torque Sequence 6. Install the fuel pump.
Refer to section 2.8.5for gear train-driven fuel pump. Refer to section 2.8.6 for air compressor-driven fuel pump. 7. Install any other components that were removed for this procedure. (Rev. 2005) All information subject to change without notice. 2-102 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION