Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 2.10.2 Replacement of Fuel Filter Replace spin-on primary and secondary fuel filters at the following intervals or earlier, if plugging is indicated: Truck and Parlor Coach — 24,000 Km (15,000 Miles) Transit Coach — 9,600 Km (6,000 Miles) Fire Fighting Apparatus — 9,600 Km (6,000 Miles) Replace the Fuel Pro ® primary filter element when the fuel level in the see-thru filter cover reaches the top of the filter element or after one year of service, whichever comes first. Replace spin-on secondary filter element at regular 250 hour intervals.

A method of determining when filters are plugged to the extent that they should be changed is based on the fuel pressure at the cylinder head fuel inlet fitting and the inlet restriction at the fuel pump. In a clean system, the maximum pump inlet restriction should not exceed 20.3 kPa (6 in. Hg) and must not exceed 41 kPa (12 in. Hg) with a dirty system. At normal operating speeds and with the standard 2.03 mm (0.080 in.) restriction fittings, the fuel pressure at the cylinder head inlet is 345-577 kPa (50-84 psi). Change the fuel filters whenever the inlet restriction at the fuel pump reaches 41 kPa (12 in.

Hg) at normal operating speeds and whenever the fuel pressure at the cylinder head inlet fitting falls to the minimum fuel pressure shown above. Spin-on type primary and secondary fuel filters used on Series 60 engines consist of a shell, element, and gasket unitized into the single cartridge and a filter cover, that includes a threaded sleeve to accept the spin-on filter cartridge. An optional fuel and water separator may be installed in place of the standard primary filter. The Fuel Pro Fuel Processor System have primary cartridge-style filter elements installed in see-thru covers mounted on top of the fuel processor bodies.

These filter elements must be changed when the fuel level in the see-thru cover reaches the top of the element. The secondary filter element must be replaced every 250 hours or every year, whichever comes first. Fuel Pro ® is a registered trademark of Davco Manufacturing, L.L.C. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-107