Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.10 DIESEL FUEL FILTERS (SPIN-ON) Replace spin-on type primary or secondary filter elements as follows: 1. With the engine shut down, place a suitable container under the filter. 2. A fuel shutoff valve may be installed on the discharge side of the secondary fuel filter. If installed, turn the handle on the shutoff valve to the closed position (perpendicular to the valve). 3. Using a suitable band-type filter wrench, remove the primary and secondary fuel filters. Dispose of the filters in an environmentally responsible manner, according to state and federal (EPA) recommendations. 4. Fill new replacement filters with clean fuel oil, and coat the gaskets lightly with clean fuel oil. NOTICE:

Overtightening may crack or distort the adaptors. 5. Thread the new filters onto the adaptors until they make full contact with the gasket and no side movement is evident. Then rotate an additional one-half turn by hand. 6. Turn the handle on the shutoff valve (if installed) to the open position (in line with the valve). (Rev. 2005) All information subject to change without notice. 2-108 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION