Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 2.11.1 Replacement of Fuel Pro 380E Fuel Filter Element Replace the Fuel Pro filter element as follows: FIRE To avoid injury from fire caused by heated diesel-fuel vapors: Keep those people who are not directly involved in servicing away from the engine. Stop the engine immediately if a fuel leak is detected. Do not smoke or allow open flames when working on an operating engine. Wear adequate protective clothing (face shield, insulated gloves and apron, etc.). To prevent a buildup of potentially volatile vapors, keep the engine area well ventilated during operation. 1. With the engine shut down and cool, place a suitable container under the fuel processor. 2.

A fuel shutoff valve may be installed on the discharge side of the fuel filter. If installed, turn the handle on the shutoff valve to the closed position (perpendicular to the valve). 3. Open the drain valve at the base of the fuel processor, and drain the fuel until it is below the level of the filter. Close the drain valve. 4. Using filter collar wrench, Part No. 23516731 or equivalent, remove the collar by turning counterclockwise. Remove the cover, filter spring, and cover seal ring by lifting straight up and over the filter element. Remove the element from the center stud (fuel outlet pipe) by pulling upward and twisting slightly. NOTE:

Current filter elements include an integral sealing grommet. Former filter elements used a separate sealing grommet. If a former element is replaced, ensure the separate sealing grommet is removed from the center stud. 5. Dispose of the used filter element and grommet in an environmentally responsible manner, according to state and/or federal (EPA) recommendations. Fuel Pro® is a registered trademark of Davco Manufacturing Corporation, L.L.C. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-115