Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.11 FUEL PRO 380/380E FUEL FILTER SYSTEM 2.11.2 Installation of Fuel Pro 380E Fuel Filter Element Install the Fuel Pro filter element as follows: 1. Ensure a sealing grommet is included in the base of the replacement element, then install the element onto the center stud. NOTICE: Do not use a wrench of any kind to tighten the collar, since this may lead to overtightening which can damage the collar and the cover. 2. Ensure the filter spring is installed at the top of the cover. If missing, the spring must be replaced to insure proper filter operation. Wipe the cover lip and cover seal clean.

After ensuring the seal is properly positioned at the base of the cover, install the cover and collar onto the fuel processor. Tighten the collar by hand until secure. NOTICE: To avoid cover or vent plug damage, do not use tools to tighten the vent cap. 3. Remove the vent cap from the top of the cover by turning the cap counterclockwise. Fill the cover full of clean fuel. After ensuring the O-ring seal is installed on the vent cap, reinstall the cap and tighten by hand only . PERSONAL INJURY Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm.

Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. 4. Open the fuel shutoff valve (if installed) and start the engine. When the lubrication system reaches its normal operating pressure, increase engine speed to high idle for 2 to 3 minutes. (Rev. 2005) All information subject to change without notice. 2-116 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION