SERIES 60 SERVICE MANUAL NOTICE: Do not allow the fuel level in the see-thru cover to fall below the top of the collar, since this may lead to interruption of the fuel flow and engine stalling. 5. After the air is purged and with the engine still running, slowly loosen the vent cap on the filter cover. The fuel level in the cover will start falling. When the fuel level falls to the top of the collar, tighten the vent cap quickly by hand. NOTICE: Do not use a wrench of any kind to tighten the collar, since this may lead to overtightening which can damage the collar and the cover. 6. Shut down the engine and hand-tighten the collar again. 7.
Refer to section2.11.2 for the exhaust caution before proceeding. Restart the engine and check for leaks. NOTE: The clear filter cover will not fill completely during engine operation. It will gradually fill over time as the filter medium becomes clogged. The filter element does not require changing until the fuel level has risen to the top of the element, or after one year of service, whichever comes first. NOTE: The secondary fuel filter must be changed at regular mile or hour intervals, depending on the engine application. Refer to section 14.6.13. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-117