Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 2.13.1 Replacement of Fuel and Water Separator Element Use the following procedure: 1. Drain off some fuel by opening the drain valve on the collection bowl. Close the valve. 2. Remove the element and bowl together, then remove the bowl from the element. Clean the bowl and the O-ring gland. 3. Apply a coating of clean fuel or grease to the new O-ring and element seal. Spin the bowl onto the new element and them spin the assembly onto the filter head by hand until snug. Do not use tools to tighten. 4. To eliminate air from the filter, operate the primer pump until the fuel purges at the filter assembly.

PERSONAL INJURY Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. 5. Start the engine and check for fuel leaks. Correct any leaks with the engine shut off. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-127