2.13 ASSEMBLY FUEL FILTER AND WATER SEPARATOR 2.13.2 Fuel Return System Check Valve The purpose of the check valve is to reduce the risk of fuel prime loss and fuel siphoning from the head when the fuel filter is removed. See Figure 2-81. Figure 2-81 Typical Fuel Return Check Valve Locations NOTICE: The check valve must be included in the fuel system. If the check valve is removed for any reason or found to be defective, a new valve must be installed and the fuel system primed before start-up. The R80 — 2.0 mm (0.080 in.) restricted fitting (elbow connector) which is ahead of the check valve must also be included in the fuel system. NOTICE:
Do not increase the size of the orifice in restricted fittings. Increasing restricted fitting hole size can cause injector cavitation, resulting in reduced durability of injectors and other engine components, and increased engine emissions. A check valve is connected to a hose in the fuel return line coming from the rear of the cylinder head or at the cylinder head restricted fitting, depending on individual installation requirements. See Figure 2-81. (Rev. 2005) All information subject to change without notice. 2-128 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION