Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.13 ASSEMBLY FUEL FILTER AND WATER SEPARATOR 2.13.4 Installation of PRO-CHEK Fuel System Check Valve The PRO-CHEK fuel system check valve is an optional item that, when properly installed, removes air from the fuel supply line between the secondary filter and the cylinder head. No priming is required even after filter change, since any air that may get into the lines is automatically removed when it reaches the PRO-CHEK valve. Install the PRO-CHEK valve as follows: 1. Mount the PRO-CHEK valve on the side or rear of the Series 60 engine. [a] If side-mounted, install with two 10 mm bolts and spacers. The location may be ahead of or behind the location shown. See Figure 2-82. 1.

Secondary Fuel Filter 4. Air Purge Line 2. Fuel Inlet 5. Fuel Outlet 3. PRO-CHEK Valve 6. Fuel Spill Line Figure 2-82 Typical Side-mounted PRO-CHEK Installation (Rev. 2005) All information subject to change without notice. 2-130 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION