SERIES 60 SERVICE MANUAL [b] If rear-mounted remove the two 12 mm bolts holding the rear lifter bracket and install the PRO-CHEK valve against the bracket with two 12 mm bolts that are 5 mm (approximately 0.20 in.) longer and two spacers. See Figure 2-83. 1. Fuel Inlet 4. Air Purge Line 2. PRO-CHEK Valve 5. Fuel Spill Line 3. Engine Lifter Bracket 6. Fuel Outlet Figure 2-83 Typical Rear-mounted PRO-CHEK Installation 2. Disconnect the fuel supply hose assembly at the rear of the engine and reconnect it to the PRO-CHEK 3/8 in. SAE flared bottom fitting marked with the words Fuel In. 3. Connect a separate fuel hose assembly to the 1/4 in.
18 NPTF PRO-CHEK female bottom fitting marked with the words Fuel Out . Install the other end in the fuel manifold inlet port at the rear of the engine. 4. An R80 2.03 mm (.080 in.) restricted fitting is installed in the fuel spill (return) opening in the cylinder head. Install a tee-fitting after the R80 spill fitting. The spill hose from this tee-fitting must be routed at least 101.6 mm (4 in.) above the fuel gallery. See Figure 2-82 and see Figure 2-83. Connect a 1/4 in. diameter fuel hose assembly to the elbow in the top port of the PRO-CHEK. Route this air purge hose to the spill tee— fitting. 5.
Tie-wrap the PRO-CHEK inlet and outlet fuel lines to prevent chafing and/or contact with metal parts. 6. Prime the fuel system. 7. Refer to section2.13.1 for the exhaust caution before proceeding. Start the engine and check for leaks. The PRO-CHEK valve is fully assembled and ready to install when received. If the Fuel In or Fuel Out fittings are accidentally loosened or removed for any reason, they must be reinstalled in their proper locations as follows: The male fitting with the long, solid pipe is installed in the fuel in port. See Figure 2-84. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-131