Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.13 ASSEMBLY FUEL FILTER AND WATER SEPARATOR The female fitting with the short, perforated pipe is installed in the fuel out port. See Figure 2-84. Figure 2-84 PRO-CHEK Valve Cutaway View Fittings must remain clean when installed, since anything that gets inside the PRO-CHEK valve will be carried into the fuel manifold and may damage the injectors. NOTICE: NOTICE: Do not overtighten the Fuel In or Fuel Out fittings or the top elbow, since this may damage the threads on the fittings or the PRO-CHEK body, resulting in fuel leaks. If fitting or body threads are damaged, the complete assembly must be replaced. 1. Thread the inspected, clean dry fittings into the valve body for a few turns. NOTICE:

Do not use Teflon ® pipe sealant tape on the male pipe fittings, since this may flake off into the fuel system and damage the injectors. 2. Apply a light coating of pipe sealant with Teflon to the visible male threads. 3. Torque the Fuel In fitting and top elbow to 14-19 N·m (10-14 lb·ft). 4. Torque the Fuel Out fitting to 19-24 N·m (14-18 lb·ft). (Rev. 2005) All information subject to change without notice. 2-132 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION