Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL Any faults that occur are stored as codes in the ECM's memory. These codes can be accessed in any of three ways: 1. A DDR can be used to read the codes. See Figure 2-91. 2. A personal computer (PC) connected to the ECM through a translator device which converts J-1708 to RS232 protocol can be used. 3. The Check Engine Light (CEL) or the Stop Engine Light (SEL) is illuminated. The CEL (panel mounted yellow indicator light) illuminated diagnose condition as soon as convenient. The SEL (panel mounted red indicator light) and CEL illuminated, a major fault occurred and immediate attention required to avoid engine damage.

Automatic engine shutdown or rampdown is available as an option. A shutdown override switch is required to allow the vehicle to be moved to a safe location during automatic shutdown or rampdown. DDEC III/IV features programmable with a Diagnostic Data Reader (DDR) are: Password Droop Active hp braking Cruise control Engine brake Vehicle speed limiting Vehicle speed sensor Variable Speed Governor cruise switch Idle timer shutdown Idle timer between air temperatures Vehicle ID number (VIN) Idle adjustment Progressive shifting Engine protection All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-143